This is designed for high quality production with pre-mill and corner rounding. Typical uses would be custom residential & commercial cabinets, closets, and work surfaces. To begin, an anti-stick spray is applied to the top and bottom surface, then Station 1 is a double motor pre-mill section. Pre-mill guarantees a cleanly cut and square edge, even if the panel did not start that way. Next an IR lamp heats the edge for the very best glue penetration and adhesion. Station 2 is motor adjusted and applies glue to the edge of the panel and then moves to the 4-roller pressure section. Station 3 is a double motor end trim. Double motors allow faster feed speeds and allows parts to be ran much closer together equaling greater output. Station 4 is motor adjusted top and bottom flat and/or radius fine trim. Station 5 is double motor corner rounding and switchable from thin to tick tape at the press of a button. Station 6 is motor adjusted top and bottom radius scraping. Station 7 is flat scrapping for a near zero glue line. Just before buffing at station 8 is a spray for buffing compound. The result is a finished edge right off the machine with no need for additional processing. The NewCNC Fuse 8 M uses digital technology to make adjustment simple at the press of a preprogrammed button. Use with PVC, ABS, acrylic, melamine, or wood veneer. Processing speeds up to 59 feet per minute are achievable.
Features
